RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
...
cat /nvram/syscfg.db | grep redirect
Code Block |
---|
root@RaspberryPi-Gateway:~# cat /nvram/syscfg.db | grep redirect
block_nat_redirection=1
redirection_flag=true |
cat /nvram/syscfg.db | grep 10.0.0.1
...
Code Block |
---|
root@RaspberryPi-Gateway:~# cat /nvram/syscfg.db | grep 10.0.0.1
HTTPS_Server_IP=10.0.0.1
lan_ipaddr=10.0.0.1
Default_Server_IP=10.0.0.1
HTTP_Server_IP=10.0.0.1 |
cat /nvram/syscfg.db | grep PartnerID
Code Block |
---|
root@RaspberryPi-Gateway:~# cat /nvram/syscfg.db | grep PartnerID PartnerID=RDKM |
ifconfig erouter0 , brlan0
Code Block |
---|
root@RaspberryPi-Gateway:~# ifconfig erouter0 erouter0 Link encap:Ethernet HWaddr B8:27:EB:50:C1:CF inet addr:192.168.0.4 Bcast:0.0.0.0 Mask:255.255.255.0 inet6 addr: fe80::ba27:ebff:fe50:c1cf/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:238 errors:0 dropped:0 overruns:0 frame:0 TX packets:276 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:38241 (37.3 KiB) TX bytes:34078 (33.2 KiB) root@RaspberryPi-Gateway:~# ifconfig brlan0 |
...
brlan0 Link encap:Ethernet HWaddr B8:27:EB:05:94:9A
inet addr:10.0.0.1 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: fe80::e862:39ff:fe51:dde7/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:40 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:3811 (3.7 KiB) |
dmcli eRT getv Device.DeviceInfo.X_RDKCENTRAL-COM_ConfigureWiFi
Code Block |
---|
root@RaspberryPi-Gateway:~# dmcli eRT getv Device.DeviceInfo.X_RDKCENTRAL-COM_ConfigureWiFi
CR component name is: eRT.com.cisco.spvtg.ccsp.CR
subsystem_prefix eRT.
getv from/to component(eRT.com.cisco.spvtg.ccsp.pam): Device.DeviceInfo.X_RDKCENTRAL-COM_ConfigureWiFi
Execution succeed.
Parameter 1 name: Device.DeviceInfo.X_RDKCENTRAL-COM_ConfigureWiFi
type: bool, value: false |
dmcli eRT getv Device.DeviceInfo.X_RDKCENTRAL-COM_CaptivePortalEnable
Code Block |
---|
root@RaspberryPi-Gateway:~# dmcli eRT getv Device.DeviceInfo.X_RDKCENTRAL-COM_CaptivePortalEnable CR component name is: eRT.com.cisco.spvtg.ccsp.CR subsystem_prefix eRT. getv from/to component(eRT.com.cisco.spvtg.ccsp.pam): Device.DeviceInfo.X_RDKCENTRAL-COM_CaptivePortalEnable Execution succeed. Parameter 1 name: Device.DeviceInfo.X_RDKCENTRAL-COM_CaptivePortalEnable type: bool, value: true |
ps | grep lighttpd // Lighttpd process should be running
Code Block |
---|
root@RaspberryPi-Gateway:~# ps | grep lighttpd 3562 root 0:00 lighttpd -f /var/lighttpd.conf 12172 root 0:00 grep lighttpd |
/nvram/hostapd0.conf
...
Code Block |
---|
root@RaspberryPi-Gateway:/nvram# cat /nvram/hostapd0.conf
# This is the name of the WiFi interface we configured above
interface=wlan0
#wlan0 is part of bridge br0
bridge=brlan0
# Use the nl80211 driver with the brcmfmac ( Broadcom BCM4334) driver
driver=nl80211
# This is the name of the network
ssid=RPi3_RDKB-AP0
# Use the 2.4GHz band
hw_mode=g
# Use channel 6
channel=06
# Enable 802.11n
ieee80211n=1
# Enable WMM
wmm_enabled=1
# Enable 40MHz channels with 20ns guard interval
#ht_capab=[HT40][SHORT-GI-20][DSSS_CCK-40]
# Accept all MAC addresses
macaddr_acl=0
# Use WPA authentication
auth_algs=1
# Require clients to know the network name
ignore_broadcast_ssid=0
# Use WPA2
wpa=2
# Use a pre-shared key
wpa_key_mgmt=WPA-PSK
# The network passphrase
wpa_passphrase=rdk@1234
# Use AES, instead of TKIP
wpa_pairwise=TKIP CCMP
rsn_pairwise=TKIP CCMP
#set the operating channel bandwidth to 20 MHz
vht_oper_chwidth=0
# The list of supported rates in units of 100kbps
supported_rates=10 20 55 110 60 90 120 180 240 360 480 540
# Basic rate set in units of 100kbps
basic_rates=10 20
#Interface for separate control program. hostapd_cli command will use it when trying to connect with hostapd.
ctrl_interface_group=0
ctrl_interface=/var/run/hostapd0
wpa_psk_file=/etc/hostapd/hostapd0.psk
eap_server=1
#wps_state=2
ap_setup_locked=1
ap_pin=45276453
wps_pin_requests=/var/run/hostapd0.pin-req
device_name=Raspberrypi
manufacturer=Broadcom
model_name=RPI-3B
model_number=BCM43438
serial_number=8965324
device_type=6-0050F204-1
os_version=01020300
config_methods=push_button keypad label display
|