Skip to end of metadata
Go to start of metadata

Required Hardware

                   The equipment listed below is required for complete functionality of the standalone environment. The only devices that are tested to work properly in this solution are the specific brands and models listed below. Support for other types of equipment is not available at this time.

  1. Raspberry Pi 3 b or Raspberry Pi 3 b+, RPI 4B device
  2. Standard USB keyboard
  3. Television set/monitor with HDMI input.
  4. Ethernet cables
  5. USB-Ethernet Adapter
  6. SD Card ( Preferably 8GB or more )
  7. Tp-link dongles
  8. USB to Serial Debugging Adaptor ( Needed only for serial debugging )


Image result for raspberry pi 3 b       

                            RPI 3B

Related image                     

                          RPI 3B+                          

USB to Serial Debug converter Link and set up

Image result for pl2303 usb to ttl 

Purchase Link(PL2303) - USB to Serial               

Image result for raspberry pi 3 b serial port connection

RPI 3 Pin Diagram

The above mentioned adaptor (PL2303) will support Linux host machine ( ubuntu ) with proper connection between RPI (for both 3B and B+) as below

  • Connect GND (Pin 6) of RPI with PL2303 GND Pin
  • Connect GPIO14 (Pin 8) of RPI with PL2303 RX Pin
  • Connect GPIO15 (Pin 10) of RPI with PL2303 TX Pin

After connection, please run minicom in host machine to establish serial connection with RPI

https://help.ubuntu.com/community/Minicom

Note : In usual, adaptor will have device name as ttyUSB0 after connected to host PC ( can be checked using dmesg command in host ). Please configure minicom accordingly. 


Note : 

Link below will provide the list of supported hardware and Peripherals supported by RPI and separate 

https://elinux.org/RPi_VerifiedPeripherals

Link for USB to Ethernet adaptors supported by RPI

https://elinux.org/RPi_USB_Ethernet_adapters


  • No labels

4 Comments

  1. Does not work the WiFi built-in in the RPI?

    1. Yes. The default wifi antennas in the Raspberry Pi are good enough for you to get a WiFi network( to which you can connect your devices )

  2. Hello,

    I have problem in build

    | cc1plus: all warnings being treated as errors 2| make: *** [Makefile:5306: src/client/linux/handler/exception_handler.o] Error 1 3| make: *** Waiting for unfinished jobs.... 4| ERROR: oe_runmake failed 5| WARNING: /home/turris-rdk/dunfell/build-raspberrypi-rdk-broadband/tmp/work/x86_64-linux/breakpad-native/git-r0/temp/run.do_compile.505176:1 exit 1 from 'exit 1' 6| ERROR: Execution of '/home/turris-rdk/dunfell/build-raspberrypi-rdk-broadband/tmp/work/x86_64-linux/breakpad-native/git-r0/temp/run.do_compile.505176' failed with exit code 1 7NOTE: recipe breakpad-native-git-r0: task do_compile: Failed 8ERROR: Task (virtual:native:/home/turris-rdk/dunfell/meta-cmf/recipes-devtools/breakpad/breakpad_git.bb:do_compile)

    1. Hi Z-André Garcia Vieira 


      Could you please share the Build VM OS version and also the build steps you followed?