Required Hardware

                   The The equipment listed below is required for complete functionality of the standalone environment. The only devices that are tested to work properly in this solution are the specific brands and models listed below. Support for other types of equipment is not available at this time.

1. Raspberry Pi 3 b or Raspberry Pi 3 b+, RPI 4B device
2. Standard USB keyboard
3. Television set/monitor with HDMI input.
4. Ethernet cables
5. USB-Ethernet Adapter
6. SD Card (Preferably 8GB or more)
7. Tp-link dongles
8. USB to Serial Debugging Adaptor (Needed only for serial debugging)

Image Removed       

                            RPI 3B

Image Removed                     

RPI-4 System Setup

Image Added

Raspberry Pi 4 Target Image

Image Added                          RPI 3B+                             

USB to Serial Debug converter Link and set up

Image RemovedImage Added 

Purchase Link (PL2303) - USB to Serial               Image Removed

RPI

...

-4 Pin Diagram

Image Added

The above-mentioned adaptor (PL2303) will support Linux host machine (ubuntu) with proper connection between RPI (for both 3B and B+) RPI4 as below

• Connect GND (Pin 6) of RPI with PL2303 GND Pin
• Connect GPIO14 (Pin 8) of RPI with PL2303 RX Pin
• Connect GPIO15 (Pin 10) of RPI with PL2303 TX Pin

Image Removed

Image Added

After connection, please run minicom in host machine to establish serial connection with RPI.

https://help.ubuntu.com/community/Minicom

...

Dongles Information Links

• For
xfinity
• Private-wifi - 2g - Purchase Link - TP-LINK TL-WN823N
• For Private-wifi
and xfinity-wifi
• - 5g - Purchase Link - TP-Link AC1300

Supported drivers for  for USB-to-Ethernet Adapters

•  ASIX based drivers  
•  r8152 driver (realtek)   driver    

 Validated USB-to-Ethernet Adapters

...