...

Feature Validation(RFC)

Configuration

RDK Feature control configuration can be added by adding below 2 sections

1. Define the Feature
2. Define the Feature Rule

• Define the feature

A new feature can be defined via RFC-> Feature -> Create. Feature name should be unique and understandable, Config data should be key value pairs, and Effective Immediate true means it will be effected immediately after the settings is obtained at CPE device.

...

Validation - TBD

Feature Validation (LogUpload)

Configuration

1. Create upload repository via DCM->Upload repository -> Create.   Here we can add where to configure the log upload, is the upload url and which protocol is used)

...

5.  Edit the Log upload Setting (Create schedule & Add the upload repository created beforehand.

Validation - TBD

Feature Validation (Telemetry)

1. Telemetry configuration can be done by adding a permanent profile which contains below objects
   1. Upload repository
   2. Profile options (Header, content, frequency etc.)
2. Creating a targeting rule which is basically mapping the profile to a set of MAC/IP/Device etc.

Configuration

1. Create a permanent profile Telemetry - > Permanent Profiles -> Create

     2. Once you save the permanent profile, you will get a message overlay ‘Profile added to the pending changes’. Then go to Changes -> select the profile you create -> Click on “Approve selected changes”.
Then the permanent profile will be listed under Telemetry - > Permanent profiles

     3. Create targeting rule via Telemetry -> Targeting rules. Targeting rules is to map the profiles with rules.