RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
...
Code Block | ||
---|---|---|
| ||
root@OpenWrt:~# fdisk /dev/mmcblk0 Welcome to fdisk (util-linux 2.32). Changes will remain in memory only, until you decide to write them. Be careful before using the write command. Command (m for help): p Disk /dev/mmcblk0: 7.3 GiB, 7818182656 bytes, 15269888 sectors Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: dos Disk identifier: 0x15344058 Device Boot Start End Sectors Size Id Type /dev/mmcblk0p1 * 2048 35327 33280 16.3M c W95 FAT32 (LBA) /dev/mmcblk0p2 36864 561663 524800 256.3M 83 Linux |
Note | ||
---|---|---|
| ||
root@OpenWrt:~# opkg update root@OpenWrt:~# opkg install fdisk |
Create a new partition partitions for RDK-B.
The devicetree database and the Linux kernel are in the FAT32 partition:
...
Follow instruction from wiki page(https://wiki.rdkcentral.com/display/RDK/Wifi-Extender+Yocto+Build+Instructions) to make yocto's RDK-B image from yocto workspace in your PC.
Boot into openwrt based linux system in turris omnia board. Its downlink interface will have 192.168.1.1 IP address and have it connected to your PC.
Check whether 'fdisk' command is available in openwrt system. if it is not present, follow below steps to have 'fdisk' command.
...
theme | DJango |
---|
Create one primary partition for zImage. Create another extended partition for holding logical partitions for rootfs and /nvram.
...