Page History

...

1.  Firmware config can be created via Firmware - > Firmware Configs -> Create. Enter a description for this config.  It will be used in the rule. Here we can define the file name and version of the image/firmware that need to be downloaded to the CPE device. The models that we defined in Common → Models section will be available here, We can select the needed models by clicking on it.

...

Build Condition should be added in the Build Conditions tabAfter we select the required template, 'Add firmware Rule' page will be displayed. Here the build conditions will be present from the 'template' that we added and in addition to that we can add additional Build Conditions also. To add firmware config , go to the 'Actions' tab and select the firmware config from 'Firmware config' drop down list.

4.  From where to download the image can be specified via The download location needs to be specified so that it can be returned in the response. Choose Firmware -> Download location filter-> Edit, where we can specify the location from where we can download the firmware. Enter the FQDN and Full http location for the firmware download server . For TFTP , we can enter the IP address and percentage. For where TFTP applies, a device will get back one of the locations below based on the percent listed for the location

...