Page History

...

• Create a folder
  $ mkdir xconf

• Step into the folder & clone the repo
  $ cd xconf/
  $ git clone https://github.com/rdkcentral/xconfserver.git -b main
  
  * 
  
  
  

4. Install and setup Cassandra(Version 3.11.9)

...

Active Profile Option (for development purpose):

If xconf-angular-admin is run with -Dspring.profiles.active=dev UI will use not compiled .js and .css files but the source files. See xconf-angular-admin/src/main/webapp/WEB-INF/jsp/xconfindex.jsp for details. That can be useful for local development purpose, to update UI it is just needed to reload page with cache refresh option.

...

7. Setting up IPV4 locations via ‘Download Location Round Robin Filter’ is not supported. This can be set only by the property 'firmwareLocation' from the 'Define Properties' firmware rule page.

8. Note : Just like we added tftp location and protocol here, we can also override the default value with http as well. For firmwareDownloadProtocol, add 'http' and for the 'firmwareLocation', add http location

Override the default download Location set at Download Location Filter

There is a new option added in the Firmware Config, where we can add parameters. For example if we add parameters 'firmwareLocation' and 'firmwareDownloadProtocol'. then we will be able to override the default download location set from the 'DownLoad Location Filter' page.

Override Firmware Location with http

To create a new firmware configuration for a particular set of devices with http download location :

1. Go to Firmware → Firmware Configs → Create. Enter a description for this config.  Also we can define the file name and version of the image/firmware that need to be downloaded to the CPE device. The models that we defined in Common → Models section will be available here, We can select the required models by clicking on it. There is also an option 'Parameters'. Add the key values 'firmwareLocation' and 'firmwareDownloadProtocol' as 'http location url' and 'http' respectively
   Image Added
2. Create a firmware rule like the steps given in 'Configuration' and map this Firmware Config to it. Check using the steps in below 'Verification' sections and verify  if the firmwareLocation and firmwareDownloadProtocol are the same as we configured in FirmwareConfig page.
   
   Sample curl response(refer below steps to check) 
   
   Image Added

Verification

a. Verification of Firmware test page.

...