Page History

<< This Page is under development>>

Host Setup

The OpenEmbedded build system should be able to run on Ubuntu 18.04 distribution/other compatible linux distribution with the following versions for Git, tar, and Python.

...

Validated Functionalities

No	Feature	Supported
1	LAN Connected Devices-Ethernet
2	WAN Connected Devices-Wi-Fi
3	Parental Control
4	Firewall settings
5	Advanced Config: Port Triggering
6	Advanced Config: Port Forwarding
7	Advanced Config: Remote Management
8	Advanced Config: DMZ
9	Xfinity Wi-Fi 2.4/5 GHz – Public Hotspot
10	Test and Diagnostics
11	Local WebUI Configuration
12	Factory Reset
13	DHCP /Reserved IP
14	EthWan
15	Eth Agent
16	2.4 GHz Band Support
17	5 GHz Band Support
18	Bridge Mode Support
19	Persistent Storage Management
20	WebPA for Comcast,community
21	Lost and Found
22	Bluetooth
22	Harvester Support
23	TR-69
24	SNMP
27	Boot time data measurement
28	Wireless Protection Setup(WPS)
29	Captive Portal
30	Wi-Fi MAC Filtering
31	Log Rotation Support
32	Firmware Upgrade Support
33	Multiboot Support
34	Telemetry Support
35	IPV6
36	Log level control through CcspLogAgent
37	Band Steering using RSSI
38	Backup and Restore
39	SelfHeal
40	Password-Reset
41	WebUI JST
42	Telemetry 2
43	RdkWanManager
44	RdkFwUpgradeManager

Known Issues

1.  E2E validation is not performed yet on 64bit aarch in RPI4 
2.  sometimes , rpi board is rebooting without giving reboot command
3.  Observing CR crash when we enabled the dbus only 
4.  None of the ccsp components are not started due to CR crash(if dbus only enabled)