RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
...
Settings->Other Settings->Advanced Settings-> Device -> Firmware Update
Select Check for Update
Note |
---|
We need to configure local http server or hfs server for validation. |
In this document, we are configuring local hfs server.
Validation performed in two devices. Amlogic skyworth and Sercomm realtek. Attaching the screenshots of those during the Validation
...
We need to follow the same steps as mentioned in the How to Prepare for XCONF Server
To view the configurations set, we can use the Firmware Test page available as part of UI.
You can specify any key value parameters here in this document Key value is used as "estbMac" and value as the <device mac address>
here download location filter is used. this is to configure for specifying local hfs server's ip and protocol
Initial screen
After clicking Check for Update the state will change to Downloading
...
Note |
---|
Other state changes are not visible in the current screen, you need to go to the previous page and has to come back to see the state changes |
Sercomm Realtek
The configuration used in Sercomm Realtek can be found same as the firmware test page as below
Initial screen
...