RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
Wi-Fi Extender Reference Targets
https://doc.turris.cz/doc/en/troubleshooting/serial_link#turris_omnia
Caution: Do not connect Vcc!
NOTE: from LGI shared shared links and information on taking serial connection and flashing OpenWRT image
PREREQUISITE: Following flashing instructions works well with U-Boot 2015.10-rc2 bootloader version. If bootloader version found to be U-Boot SPL 2019.07 in your Turris Omnia, then please follow steps in Bootloader Downgrade section below in this page.
The Omnia ships with TurrisOS preinstalled. This is an OpenWrt fork with the older Linux 4.4 kernel. It uses btrfs to manage the eMMC flash.
...
Now, Turris Omnia will boot with Yocto based RDKB image.NOTE
Fallback to OpenWrt OS:
To fallback to openwrt OS, enter following u-boot commands.
|
Yocto image upgrade procedure from OpenWrt OS: (Better approach is welcome)
Go back to OpenWrt OS (please refer Fallback to OpenWrt OS section above ).
Have Ethernet connection from your PC to LAN port of Turris Omnia.
Run following commands from inside OpenWrt OS.
Code Block |
---|
root@OpenWrt:/# scp manigandan@192.168.2.83:BOX/*$1* /tmp/
root@OpenWrt:/# mount /dev/mmcblk0p3 /mnt
root@OpenWrt:/# mv /tmp/zImage-* /mnt/zImage
root@OpenWrt:/# umount /mnt
root@OpenWrt:/# mount /dev/mmcblk0p5 /mnt
root@OpenWrt:/# rm -rf /mnt/*
root@OpenWrt:/# tar -xzf /tmp/rdkb-* -C /mnt/
root@OpenWrt:/# umount /mnt
root@OpenWrt:/# reboot |
Press enter while turris omnia reboots to get into u-boot prompt. Then type following u-boot commands to get back to Yocto based RDKB image.
|
Turris Omnia is now running upgraded version of Yocto based RDKB image.
Bootloader Downgrade:
(Following steps are derived from https://wiki.debian.org/InstallingDebianOn/TurrisOmnia#Bootloader_update)
...