Page History

• Introduction
• Yocto Build Steps
• Image Flash Procedure
• Firmware Upgrade Validation Procedure
  • TFTP Server Setup
  • XCONF Server Setup
    • XConf URL
    • Create Environments
    • Create Model
    • Create MAC List
    • Create Firmware config
    • Create Firmware Rule
    • Edit Download Location Round Robin Filter
    • Verify XConf server configuration
  • Activate the System Serivce Plugin in the Controller UI
  • Provide the UpdateFirmware Curl command in the Rpi board
  • RPI-Board
• Conclusion

Introduction

...

Refer below link to build rdkv image

Yocto Build Instructions - RPi - RDK Video - 2020 - M12#196872666

Image Flash Procedure

Image Flash step

...

...

• Build the image RDK-V Image.
  
• Ensure 8GB sd-card is available for flashing
• Flash the build image to sd-card
• Setup xconf server ready with rules and download location for RPI device
• Place the upgrading image and checksum file in tftp server
• Boot the flashed image
• Activation of System Service plugin in controller UI before executing Curl command
  
• Curl command need to be provide twice initiailly after the RPI board bootup ,curl command for the creation of 2 more additional partitions  (ex. mmcblk0p3, mmcblk0p4) in /dev folder.and again after the auto-reboot of the RPI board curl command for image downloadedownload