Architecture

The following diagrams show how WAN Manager will communicate with PPP Manager to set up PPP connections.

Fixed WANoE (PPPoE)

This diagram shows how a PPPoE connection should be established for a WANoE interface in Fixed Mode.

This sequence applies to all PPPoE connections (including PPPoEoA), regardless of the base interface.



The Device.X_RDK_WanManager.CPEInterface.{i}. data model is expected to be configured as follows:

IndexNameWan PriorityPPP Link TypeActive Link

1

eth3

0 (highest)

PPPoE

True


Fixed ADSL (PPPoA)

This diagram shows how a PPPoA connection should be established for an ADSL interface in Fixed Mode.

This sequence applies to all PPPoA connections (not including PPPoEoA), regardless of the base interface. Note: VLAN interfaces will not be created for PPPoA connections. The PPP interface will be created directly on top of the base ATM interface.


The Device.X_RDK_WanManager.CPEInterface.{i}. data model is expected to be configured as follows:

IndexNameWan PriorityPPP Link TypeActive Link
1atm00 (highest)PPPoATrue
  • No labels

DISCLAIMER: Please note that the use of the RDK Wiki is subject to its Privacy Policy & Terms of Use. In addition, this Wiki may be accessed by all RDK licensees and their contractors.