RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
...
Create MAC rule by providing rule name, Build condition is eStbMac, choose the option IN_LIST and for next field, select the MAC list created for RPi board, verify that based on the MAC list selection, Firmware Config will be automatically displayed under Action section.
6) Go to
...
1.Select Download Location filter under the firmware tab in XCONF UI
2.click the edit button
3.Enter the "Location (FQDN)" field is local/Public http server (fully qualified domain name ) (ex : www.myfirmware.com)
4.Enter the "Location (full URL)" field is full location path of local/Public http server (ex : http://www.myfirmware.com)
5.Unclick the check box of Never use HTTP
6. Removed the model name from Rogue Models.
7.Removed the firmware version (If it's not updated earlier, please ignore this step).
8. click the save button.
9.In DUT, please edit the following file with below format,If it's local http server
i) Open the /etc/hosts
ii) Add your local http server ip with DNS ( Ex : 192.168.0.128 www.myfirmware.com)
iii) Save the file.
Note : Every reboot, You need to add the above three steps if it's local http server.
...
Provide TFTP Server IP address in the IPv4 locations and provide 100 in the percentage field. If there are multiple TFTP servers then add them under IPv4 locations and distribute the percentage among them like total should be 100% and save this page.
7. Verify that XConf Server configuration displays the Json response from the mentioned URL:
Using the below url to view the JSON Format result of http protocol ,
http://<Xconf Server IP:port no.>35.155.171.121:9092//xconf/swu/stb?eStbMac=<RPI MAC ADDRESS>&model=<model_name>&capabilities=RCDL&capabilities=supportsFullHttpUrl
=<MAC address of Rpi board>
3. Verify the tftp folder location:
...