RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
Children Display |
---|
Table of Contents |
---|
The Firmware upgrade will upgrade higher or lower version of the current image in RPI target with the help of Xconf server and Local TFTP server.
This page dedicated to bringing up and validation of Firmware upgrade in R-Pi Zero.
Refer below link for RPI-0 Environment setup
Refer below link to build camera image
RDK-C Build Instructions Instruction for RRPI-Pi0
Code Block | ||||
---|---|---|---|---|
| ||||
$ sudo dd if="Image Name" of="Device Name" bs=4M Example: sudo dd if=rdk-generic-camera-image_default_20200130060729.rootfs.rpi-sdimg of=/dev/sdb bs=4M |
STEP 1:
Install xinetd and tftpd-hpa application in your local PC to setup tftp server by using below command
...
Code Block | ||
---|---|---|
| ||
sudo service tftpd-hpa restart sudo /etc/init.d/xinetd restart |
Enter XConf server wiki page with below URL to create Environment,Model,Mac list,Firmware config,Firmware rule and Download Location Round Robin Filter.
Code Block | ||||
---|---|---|---|---|
| ||||
http://35.155.171.121:9093/admin/ux |
STEP 1:
Select Environments option within common list to enter Environments page.
...
Give ID and Description to setup Environment for your device and save that details in xconf server..
STEP 1:
Select Models option within common list to enter Models page.
...
Give ID and Description to setup Model for your device and save that details in xconf server..
STEP 1:
Select MAC Lists option within common list to enter MAC Lists page.
...
Give Name and Data to set MAC detail for your device and save that details in xconf server..
Ensure application type is stb. If the application type is xhome then change application into stb.
...
Give Description,File name ( Upgrading image name ),Version( Upgrading image name without .rootfs.rpi.sdimg) and select your model name and save the details in xconf server.
STEP 1:
Select Firmware Rule option within common list to enter Firmware Rule page.
...
Select your firmware config under Action option and save your Firmware rule in XConf server.
STEP 1:
Select Download Location Filter option within common list to enter Download Location Filter page.
...
Give TFTP server running IP address to download image.
Verify that XConf Server configuration displays the Json response from the mentioned URL:
...
For Ex: http://35.155.171.121:9092/xconf/swu/stb?eStbMac=B8:27:EB:2E:72:2B
Please find the summary on firmware upgrade explained above
...
RPI will support only tftp protocol . No http protocol support is provided yet.