RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
...
Function | Description |
dpoe_getOnuId | The ONU ID is a non-volatile number that uniquely identifies a physical DPoE ONU. All logical links on a DPoE ONU report the same DPoE ONU ID, despite having different link MAC addresses. This function is called to fetch the DPoE parameter: Device.DPoE.Mac_address |
dpoe_getFirmwareInfo | The DPoE ONU firmware version number uniquely identifies a particular version of the ONU firmware. Format is defined by the ONU vendor. This function is called to fetch the DPoE parameters listed below: Device.DPoE.DPoE_FirmwareInfo.bootVersion |
dpoe_getManufacturerInfo | This function will return information corresponding to multiple OAM messages. This function is called to fetch the DPoE parameters listed below: Device.DPoE.DPoE_ManufacturerInfo.info |
dpoe_getMaxLogicalLinks | The maximum number of logical links the ONU supports on the EPON. |
dpoe_getNumberOfNetworkPorts | This attribute provides the total number of TU interface ports on the ONU. This function is called to fetch the DPoE parameter: Device.DPoE.NumberOfNetworkPorts |
dpoe_getNumberOfS1Interfaces | This attribute provides the number of S1 interfaces on the DPoE ONU. This function is called to fetch the DPoE parameter: Device.DPoE.NumberOfS1Interfaces |
dpoe_getOnuPacketBufferCapabilities | This message provides a means for the DPoE ONU to convey information about packet buffer capabilities to the DPoE System. This function is called to fetch the DPoE parameters listed below: Device.DPoE.DPoE_OnuPacketBufferCapabilities.upstreamQueues |
dpoe_getLlidForwardingState | This attribute represents the current traffic state for an LLID. This function is called to fetch the DPoE parameters listed below: Device.DPoE.DPoE_LlidForwardingState.link |
dpoe_getOamFrameRate | This attribute represents the maximum rate at which OAM PDUs are transmitted on a link. This function is called to fetch the DPoE parameters listed below: Device.DPoE.DPoE_OamFrameRate.link |
dpoe_getDeviceSysDescrInfo | This function will return multiple pieces of device system information: Vendor Name, Model Number, HardwareInfo. This function is called to fetch the DPoE parameters listed below: Device.DPoE.DPoE_DeviceSysDescrInfo.vendorName |
dpoe_getEponMode | This attribute represents the EPON mode(s) supported by this ONU. |
dpoe_setResetOnu | This attribute resets the ONU, as if from power on. |
dpoe_getDynamicMacAddressAgeLimit | This attribute represents Dynamic MAC learning table age limit. |
dpoe_getDynamicMacLearningTableSize | This attribute is a capability attribute that represents the maximum size of the DPoE ONU MAC address learning table for the entire DPoE ONU. |
dpoe_getDynamicMacTable | This attribute represents the dynamically learned MAC address rules. |
dpoe_getStaticMacTable | This attribute represents the statically provisioned MAC address table |
dpoe_getMacLearningAggregateLimit | This message represents the aggregate dynamic MAC address limitfor the DPoE ONU as a whole. This is the maximum number of addresses that can be learned by all ports combined. |
dpoe_setClearOnuLinkStatistics | This function will clear all statistics for the DPoE ONU. |
dpoe_hal_Reboot_Ready | Get the Reboot Ready Status |
dpoe_hal_ReinitMac | Reinit DPoE. Performs reinit MAC only to same DS/US |