RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
Table of Contents | ||
---|---|---|
|
EthWAN | Docsis |
---|---|
GwProvApp-EthWan is used for EthWan configuration | GwProvApp is used for Docsis configuration |
Default CR device profile used is cr-ethwandeviceprofile.xml | There is a dependency on CM agent. |
parodus2ccsp, xsmart ,ccsp LM lite and webpa are not having dependencies on CM agent | DML is used to verify in which MODE the box is currently operating |
WEBPA & Reverse SSH is working over WAN MAC assigned to ifconfig erouter0 interface | The Device is using CM MAC as defined in hardware system |
XB6 Ethernet Port 1 must not be available for LAN side connections | Ethernet Port 1 must be usable for LAN side client connectivity |
The Cable Modem is not active and there is no active CM IP address | Cable Modem is active and there is active CM IP Address |
...
draw.io Diagram diagramName ONU.drawio revision 1 Gliffy Diagram macroId 0621c089-c7fa-466d-812f-6d35479c897b name ONU pagePin 2
DM | Description |
---|---|
Device.Ethernet.X_RDKCENTRALCOM_WAN.Enabled | The DML is used to ON/OFF the EthWan Feature. The default value is OFF. |
Device.Ethernet.X_RDKCENTRALCOM_WAN.Port | The DML provides the port number that is configured if the feature is ENABLED with Device.Ethernet.X_RDKCENTRAL-COM_WAN.Enabled |
Device.DeviceInfo.X_RDKCENTRALCOM_EthernetWAN.CurrentOperationalMode | The DML is used to verify in which MODE the box is currently operating |
No Format |
---|
dmcli eRT setv Device.Ethernet.X_RDKCENTRAL-COM_WAN.Enabled bool True dmcli eRT setv Device.Ethernet.X_RDKCENTRAL-COM_WAN.Port uint 0 |
...
No Format |
---|
Gateway> Connection > WAN Network |
Ccsp EthAgent Dmcli Code flow
Gliffy Diagramdrawio | ||||
---|---|---|---|---|
|
GW Prov Ethwan Code flow
draw.io Diagram | ||||||
---|---|---|---|---|---|---|
| ||||||
Gliffy Diagram | ||||||
|
Commands to get EthWAN info from hal
Command | Description |
---|---|
hal_test ethwan enableEthwan | To enable EthWan |
hal_test ethwan disableEthwan | To disable EthWan |
hal_test ethwan GetEthWanInterfaceName | To get the EthWan Interface name |
hal_test ethwan getEthWanEnabled | To get the EthWan status (enabled or disabled) |
hal_test ethwan getEthWanPort | To know which port is enabled for EthWan feature |
hal_test ethwan setEthWanPort_eth0 | Set eth0 port as EthWan interface |
hal_test ethwan setEthWanPort_eth1 | Set eth1 port as EthWan feature |
https://wiki.rdkcentral.com/courses/playcourse.action?course=90113230&capsule=3
...