RDK Resources
[*RDK Preferred*]
Code Management Facility
RDK Forums
[RDK Conferences]
RDK Support
Archives
Papers & Presentations Archive
This Page is under Development
Self Heal is a monitoring and recovery module.
It continuously monitors the system resources like CPU and Memory and monitors the critical Processes running.
Self heal also performs Connectivity tests.
In case of any problems encountered, Self Heal takes corrective actions like: Rebooting the device, Restarting required process based on predefined conditions.
Self-heal stores Reset Count and Reboot Count.
Self Heal is enabled by default and is active at the time of boot up.
It periodically performs below actions.
To enable or disable "Self Heal" functionality, use below command:
syscfg set selfheal_enable true
<Identify the error messages that a user may receive and the likely cause(s) and/or possible corrective actions for the error>
<If applicable, describe any special circumstances, actions, exceptions, etc., that should be considered for troubleshooting.>
Contact | Organization | Phone | Role | |
<Contact Name> | <Organization> | <Phone> | <Email> | <Role> |